Xerox Phaser 6120 - CONNECTION SETUP MENU

About the Control Panel36
CONNECTION SETUP MENU
With this menu, interface settings can be specified.
" Restart the printer after changing settings in the
NETWORK SETUP menu.
" All factory default values are shown in bold.
NETWORK
SETUP
TCP/IP ENABLE
Settings
YES/NO
If YES is selected, TCP/IP is enabled.
If NO is selected, TCP/IP is disabled.
DHCP/
BOOTP
Settings
ON/OFF
Select whether or not the IP address is
automatically acquired.
If YES is selected, the IP address is
automatically acquired.
If NO is selected, the IP address is not
automatically acquired.
IP
ADDRESS
Setting
192.168.1.2
Set the IP address for this printer on the
network.
Use the Up, Down, Left, and Right keys
to specify the value.
If the IP address is manually specified,
DHCP/BOOTP is automatically set
to
NO.
DEFAULT
ROUTER
Setting
192.168.1.2
Specify the IP address of the router if
one is on the network. Use the Up,
Down, Left, and Right keys to specify
the value.