Xerox Phaser 6510 User Manual

Symptom
Probable Causes Solutions
them if necessary. For details, refer
to Consumables.
• Vertical black or color streaks or
multiple colored streaks or
lines.
• Streaks in only one color.
The toner cartridges are not
Xerox
®
toner cartridges.
Ensure that the toner cartridges
meet specifications and replace
them if necessary. For details, refer
to Consumables.
Debris in the printer is dragging
against the toner before it is
fused.
Remove any debris or paper scraps
from the paper path under the
rear cover.
There is a problem with the toner
cartridge for that color.
Check the toner cartridge for
damage and replace if necessary.
For assistance, go to the Xerox
®
Support website at www.xerox.
com/office/6510support.
Partial blanks, creased paper, or
blotted printing.
The paper is damp. Replace the paper.
The paper is outside the
recommended specification range.
Replace the paper with a
recommended size and type. For
details, refer to Supported Paper.
The printer is worn or damaged. For assistance, go to the Xerox
®
Support website at www.xerox.
com/office/6510support.
The toner cartridges are not
Xerox
®
toner cartridges.
Verify that the toner cartridges
meet specifications and replace if
necessary. For details, refer to
Consumables.
The paper is impeded in the paper
path.
• Remove any paper or debris
from the paper path.
• Ensure that the trays are
pushed in all the way.
• Ensure that the rear cover is
closed and locked.
Condensation inside the printer
causes partial blanks or creased
paper.
Power on the printer and leave it
on for at least one hour to get rid
of the condensation. For
assistance, go to the Xerox
®
Support website at www.xerox.
com/office/6510support.
Vertical blanks appear. The LED lenses are blocked. Clean the LED lenses. For details,
refer to Cleaning the LED Lenses.
142
Xerox
®
Phaser
®
6510 Printer
User Guide
Troubleshooting

Xerox Phaser 6510 Specifications

General

Brand	Xerox
Model	Phaser 6510
Category	Printer
Language	English