Xerox Phaser 6510 User Manual

Symptom
Probable Causes Solutions
driver match the paper loaded in
the tray.
The settings in the application or
print driver are incorrect.
Print the Demo Page. For details,
refer to Printing Reports. If the
Demo Page looks correct, the
printer is printing properly. Verify
that the application and the print
driver selections are correct for
your print job.
The paper is damp. Replace the paper.
The high-voltage supply is
defective.
For assistance, go to the Xerox
®
Support website at www.xerox.
com/office/6510support.
Only one color is faded.
Toner cartridge is empty or
damaged.
Check the condition of the toner
cartridge and replace it if
necessary.
Color around the edge of printing
is incorrect.
The color registration is incorrect. Adjust the color registration. For
details, refer to Color Registration.
Stray black dots or white areas
(dropouts).
The paper is outside the
recommended specification range.
Replace the paper with a
recommended size and type, and
confirm that your control panel
and print driver settings are
correct. For details, refer to
Supported Paper.
There is debris on the rollers. Wipe the feed rollers with a clean
damp cloth to remove debris from
the rollers.
Do not touch the transfer roller or
the exposed end of the transfer
belt. Fingerprints can cause print-
quality issues.
The toner cartridges are not
Xerox
®
toner cartridges.
Ensure that the toner cartridges
meet specifications and replace
Xerox
®
Phaser
®
6510 Printer
User Guide
141
Troubleshooting

Xerox Phaser 6510 Specifications

General

Brand	Xerox
Model	Phaser 6510
Category	Printer
Language	English