RReesseettttiinngg tthhee PPrriinntteerr
Using Software Resets to restart the printer is faster and wastes fewer consumables than powering
the printer on and off. Restarting the printer can take several minutes, during which time the
Embedded Web Server is not available.
1. At your computer, open a Web browser. In the address field, type the IP address of the printer,
then press Enter or Return.
2. In the Embedded Web Server, click Home→Support→Restart Device.
3. At the prompt, click Restart.
CCoonnffiigguurriinngg AAlleerrttss
1. At your computer, open a Web browser. In the address field, type the IP address of the printer,
then press Enter or Return.
2. In the Embedded Web Server, log in as a system administrator. For details, refer to Logging In as
the Administrator.
3. On the Home page, for Supplies, click Details.
4. For Options, click Alerts Setup.
5. To enable alerts, for Enable Alerts, click the toggle button.
Note: A check mark on the toggle button indicates that the setting is enabled.
6. To enable or disable an alert, for the alert type, select the appropriate option:
• Click the toggle button.
• Click the alert type, then select an option from the list.
7. Click OK.
CCoonnffiigguurriinngg tthhee SSMMTTPP SSeerrvveerr SSeettttiinnggss
Before you can configure email alerts, configure the printer to communicate with your SMTP email
server.
To configure the SMTP server settings:
1. At your computer, open a Web browser. In the address field, type the IP address of the printer,
then press Enter or Return.
2. In the Embedded Web Server, log in as a system administrator. For details, refer to Logging In as
the Administrator.
3. Click Connectivity.
4. Click SMTP.
5. To enable Email Submission, click the Email Notification toggle button.
Note: A check mark on the toggle button indicates that the feature is enabled.
6. Type the following information:
158
Xerox
®
Phaser
®
6510 Printer
User Guide
System Administrator Functions
To Next Page
Loading...
