12. To save the information and close the Tray Properties window, touch OOKK.
13. Run your print job.
• If the paper is fed accurately without skew and the printed output is successful, your task is complete.
• If the paper is skewed and the printed output is unsuccessful, proceed to the next step.
14. Pull out the tray until it stops.
15. Return the right-side skew adjustment lever toward the rear of the paper tray. This is the default position of
right-side skew adjustment lever.
16. Gently push in the tray until it stops.
17. If you are still having skew adjustment problems, refer to the Advanced Stock Setup information located in the
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer System Administrator Guide.
CLEARING OHCF JAMS
Tip: Always ensure that all paper jams, including any small torn pieces of paper, are cleared before proceeding with
your print jobs.
Note: Remedies to remove jammed paper differ according to the paper jam location. To remove jammed
paper, follow the instructions that appear on the control panel.
Paper Jams Inside the OHCF Trays
1. Pull out the tray slowly where the paper jam occurred.
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide 321
Oversized High Capacity Feeder
To Next Page
Loading...
Need help?
General
