• If you remove the Wi-Fi network connection module, the primary network connection is set to Ethernet.
The following features are available only over the primary network connection:
• IPsec
• SMTP
• SNTP
• WSD scan
• Scan to SFTP, Scan to SMB, Scan to Email
• LDAP
• UPnP discovery
• ThinPrint
• EIP Web Service
To configure the primary network at the control panel:
1. At the printer control panel, press the HHoommee button.
2. Log in as administrator. For details, refer to the System Administrator Guide at www.xerox.com/office/
VLB71XXdocs.
3. Touch DDeevviiccee >> CCoonnnneeccttiivviittyy >> PPrriimmaarryy NNeettwwoorrkk.
4. Select the appropriate network connection type for the device.
5. To apply the changes and restart the device, at the prompt, touch RReessttaarrtt NNooww.
Connecting to Wi-Fi Direct
You can connect to your printer from a Wi-Fi mobile device, such as a tablet, computer, or smartphone, using Wi-Fi
Direct. Wi-Fi Direct is disabled by default.
Note: Wireless networking is available only on printers with the optional Wireless Network Adapter installed.
CCoonnnneeccttiinngg wwiitthh WWii--FFii DDiirreecctt ffrroomm YYoouurr MMoobbiillee DDeevviiccee
To connect with Wi-Fi Direct, follow the directions provided with your mobile device.
CONNECTING TO A TELEPHONE LINE
WWaarrnniinngg:: To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.
1. Ensure that the printer is powered off.
2. Connect a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to the Line port on the back of
the printer.
3. Connect the other end of the RJ11 cable to an operating telephone line.
4. Power on the printer.
Xerox
®
VersaLink
®
B71XX Series Multifunction Printer User Guide 51
Getting Started
To Next Page
Loading...
Need help?
General
