4. Insert the tab stock into the tray so the straight edge of the stock is in the feed
direction (lead edge) and the tabs are to the left (trail edge).
5. Continue to insert the tab stock into the tray until it stops.
6. Adjust the paper guides so that they touch the edges of the stack.
7. If the Paper Tray settings/Tray Properties window displays on the UI, confirm the
correct tray to which it is printing and other information, including size, type (precut
tab), and, if necessary, paper curl and/or alignment option.
8. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.
Loading Transparencies in the Bypass (Tray 5)
Note
Do not use transparencies with a white side strip (either permanent or removable).
1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.
2. Hold the center of the paper guides and slide them to the desired paper size.
3. Select the appropriate paper stock for your print/copy job.
4. Fan the transparencies to stop them from sticking together before loading into the
tray.
5. Insert the transparencies LEF into the tray with the side to be printed on face up and
with the removable stripe to the right.
6. Continue to insert the paper or media into the tray until it stops.
7. Adjust the paper guides so that they touch the edges of the stack.
8. From the Paper Tray settings/Tray Properties window, enter the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment
option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.
Loading Pre-drilled Stock in the Bypass (Tray 5)
1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.
2. Hold the center of the paper guides and slide them to the desired paper size.
3. Select the appropriate paper stock for your print/copy job.
4. Fan the sheets before loading them into the tray.
5. Insert the pre-drilled stock into the tray in the LEF direction with the holes to the
right.
6. Continue to insert the paper or media into the tray until it stops.
7. Adjust the paper guides so that they touch the edges of the stack.
8. From the Paper Tray settings/Tray Properties window, enter the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment
option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.
Xerox
®
Versant
®
180 Press4-10
User Guide
Paper and Media
To Next Page
Loading...
