Important
Before this feature can be set up and used, it must be enabled by a Service Representative.
Contact the Customer Support Center to schedule an appointment with a Service
Representative. Tell the Customer Support Center that NVM 780-119 must be changed
from a value of 0 to a value of 1.
How the Jam Recovery Offset Feature Works
When a jam occurs while printing offset output, the first sheet after recovery (jam
clearance) is an insert that is pulled from a tray that is selected by the user. For example:
1. While setting up the Jam Recovery Offset Feature, the user selected Tray T1
(Post-Process Inserter) as the tray to use for offset jam recovery.
2. Tray T1 is loaded with colored stock, such as yellow paper.
3. A jam occurs while printing offset output.
4. The user removes the sheets in the paper path per the press User Interface (UI)
screens.
5. The press “recovers” by feeding first a yellow sheet from T1, and then the offset in
the set.
6. At that point, it is easy for the user to verify if all pages are present in the job by
accessing the set with the “Yellow” insert.
Conditions Required for the Jam Recovery Offset Feature to Work
For the insert paper to work correctly, the following conditions needs to be met:
• A specific paper tray must be selected for the jam recovery insert sheet.
• The selected paper tray must be operational; the selected tray cannot be broken.
• The selected paper tray must be installed with your system.
In other words, you cannot assign the jam recovery insert sheet to the Top Tray of
the Standard Finisher because your system only has a High Capacity Stacker (HCS)
attached. Therefore, you must select the HCS for the insert sheet.
• The selected paper tray must support the desired paper size for the insert sheet. For
example:
- You want the jam recovery sheet to be 11 x 17 in. / A3 size.
- You try to assign it to the 1-Tray High Capacity Feeder (8.5 x 11 in. / A4).
- The 1-Tray HCF does not support 11 x 17 in. / A3 size.
Setting Up the Jam Recovery Offset Feature
1. Press the Log In/Out button on the press UI.
2. Enter the system administrator Login ID with the numeric keypad, and select Enter.
The default Login ID value is admin, and the default password is 1111.
Note
By default, the password prompt is not enabled.
3. Press the Machine Status button on the UI.
Xerox
®
Versant
®
180 Press6-28
User Guide
Troubleshooting
To Next Page
Loading...
Need help?
General
