Xerox WorkCentre 5330 User Manual

Installation and Setup
WorkCentre 5300 Series Multifunction Printer
User Guide
40
3. Close the front cover.
4. Press the power switch, visible on the lower center tray, to the on position to turn the printer on.
The printer takes approximately 35 seconds to warm up before use.
Note: When the optional Office Finisher LX is attached, the power switch is located behind a clear
plastic door in the finisher transport cover/center tray.
Turning the Printer Off
Press the power switch, visible on the lower center tray, to the off position to turn the printer off.
Internal processing takes place before the printer shuts off.
Notes:
• Wait five seconds after any active job completes before turning the printer off.
• When the optional Office Finisher LX is attached, the power switch is located behind a
clear plastic door in the finisher transport cover/center tray.
Power switch Power switch with optional Office Finisher LX
Power switch Power switch with optional Office Finisher LX
wc53xx-008
wc53xx-009
wc53xx-013
wc53xx-012

Xerox WorkCentre 5330 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	Up to 30 ppm
Print Resolution	Up to 1200 x 1200 dpi
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Hard Drive	80 GB
Copy Speed	Up to 30 cpm
Operating System Compatibility	Windows, Mac, Linux
Connectivity	USB 2.0
Paper Sizes	A4, A5, B5
Scan Destinations	Scan to Email, Network, USB
Fax Speed	33.6 kbps
Duplex Printing	Automatic