Security
Xerox
®
WorkCentre
®
6655 Color Multifunction Printer 103
System Administrator Guide
4. If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are Disabled, IPv4 Address, or IPv6 Address.
5. Under IPsec Security, select ESP, AH, or BOTH.
6. Type the Key Lifetime, and select Seconds, Minutes, or Hours.
7. Under Perfect Forward Secrecy (PFS), select None, Group 2, or Group 14.
Note: PFS is disabled by default. PFS allows faster IPsec setup, but is less secure.
8. Under Hash, select from the following:
− SHA1
− None
9. If you selected ESP or BOTH for the IPsec Security type, select one or more of the following
Encryption types:
Note: If the IPsec Security type is set to AH, the Encryption type options do not appear.
− AES
− 3DES
− Null
10. Click Save to apply the new settings or Undo to retain the previous settings.
Editing or Deleting an Action
To edit or delete an action, select the action from the list, then click Edit or Delete.
To Next Page
Loading...
Need help?
General
