Xtool IP500-TLS - Internal Battery Pack; AC Power Supply; 12-Volt Vehicle Power; Technical Specifications

4
1.5 Internal Battery Pack
The IP500-TLS Diagnostic Tool can be powered from the internal rechargeable
battery pack. A fully charged battery provides sufficient power for about 3.5 hours of
continuous operation.
Battery charging occurs when the Diagnostic Tool is connected to the AC Power
Supply and to a live AC power source.
1.6 AC Power Supply
You can power the Diagnostic Tool by connecting it to a standard AC outlet using the
AC power supply. The connector at the end of the output cable from the AC power
supply should be plugged into the DC power supply input jack located on the top of
the Diagnostic Tool. It's important to use only the AC power supply that was
provided specifically for this purpose to ensure proper and safe operation of the
tool.
1.7 12-Volt Vehicle Power
Locate the vehicle's OBDII port, which is typically found beneath the driver's seat,
near the steering wheel. Insert the 16-pin connector of the OBDII cable into the
vehicle's OBDII port, and connect the 15-pin end of the OBDII cable to the device,
tightening the screw to ensure a secure connection.
1.8 Technical Specifications
Item
Description/Specification
Display
5.45 Inch（1440*720 Resolution）
Operating System
Linux
Protocols Supported
CAN FD
Processor
Quad-core 1.2 Hz
Memory
128M+32G (supports memory expansion up to
128G)
Connectivity
Type-C
Operating Method
Flat Panel Touchscreen
Upgrade Method
Device Connects to Wi-Fi for Online Upgrade