NOTE:
The images and illustrations depicted in this manual may differ from the actual ones
due to color discrepancies and image reproduction quality.
Turn on/off or Force Shutdown
The following sections explain how to turn the XTOOL IP500-TLS Diagnostic Tool on
and off, as well as how to perform an emergency shutdown.
2.1 Turning On
To turn on the XTOOL IP500-TLS Diagnostic Tool, press and hold the power button
located on the top right of the device for approximately five seconds. The tool will
automatically power on if the internal battery pack has sufficient charge or if it is
connected to an AC power supply. If the internal battery pack is completely drained,
you need to charge it for more than 6 hours and then turn it on again.
2.2 Turning Off
To turn off the XTOOL IP500-TLS Diagnostic Tool, press and hold the power button
for more than three seconds. The tool will then automatically power off.
IMPORTANT:
Before turning off the XTOOL IP500-TLS Diagnostic Tool, make sure to terminate all
vehicle communications. If you try to power off the tool while it is still
communicating with the vehicle, a warning message will appear. Forcing a shutdown
during communication could potentially cause issues with the ECM (Engine Control
Module) on certain vehicles. It's crucial never to disconnect the DBD-15 main cable
while the Diagnostic Tool is actively communicating with the vehicle ECM.
2.3 Emergency Shutdown
During normal operation turn the Diagnostic Tool off using the Turning Off procedure
To Next Page
Loading...
