10. Compliance Information
10.1 FCC Compliance / FCC ID: 2AW3IF510
This device complies with Part 15 of the FCC rules and Industry Canada’s
license-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Cet appareil est conforme aux CNR exempts de licence d’Industrie Canada.
Son fonctionnement est soumis aux deux conditions suivantes:
1. Ce dispositif ne peut causer des interferences; et
2. Ce dispositif doit accepter toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement de l’appareil.
WARNING:
Making changes or modifications without explicit approval from the responsible
compliance authority may revoke the user's authorization to operate the equipment.
NOTE:
This equipment has undergone testing and meets the requirements for a Class B
digital device, as stipulated by Part 15 of the FCC Rules. These standards are
intended to offer reasonable protection against interference when installed in
residential environments.
This equipment emits radio frequency energy during operation, which can
potentially interfere with radio communications if not installed and used as per the
provided instructions. While efforts are made to minimize interference, there is no
assurance that it will not occur in specific installations. If interference affects radio or
television reception, you can determine if this equipment is the cause by powering it
off and on. To mitigate such interference, consider the following measures:
To Next Page
Loading...
