Actuation Test= Active Test=Component Test= Bi-Directional Control
12.3 FAQs
Q1: I haven't found I/M readiness in the menu.
A: Click the "OBD-II" icon >Auto Scan/Select OBD-II Protocol>I/M Readiness
Q2: Unable to find live sensor data as the generic OBD2 scanner, like
short-term/long-term fuel trim.
A: Click the "OBD-II" icon >Auto Scan/Select OBD-II Protocol>Live Data>LTFT, STFT or
similar term .
Q3: Unable to find the misfire data for my Ford/Dodge/Chrysler/Jeep cars?
A: OBD-II >Auto Scan or Select OBD-II Protocol for your car>On Board Monitor
Test>Select "Misfire Cylinder Data" or similar term.
Q4: I can not charge the battery now. I plugged in the cord, it's not charging. The
battery is almost dead, only about 10% left.
A: 1. Try to use the original charging cable or OBD test cable to charge the device for
more than six hours. (Using the original charging cable to connect the power supply
with a stable 12V voltage is preferred)
2. Hold down the shutdown button for 15 seconds and observe whether the device
can be turned on normally. (Do not connect the charging cable)
1. Connect the device to the computer through the USB cable to see if the device
can be recognized by the computer.
4. If neither of the above methods successfully charges the device, please contact
our technical support: support@xtoolonline.com and send a video showing the
charging issue.
Q5: Can scanner tune up car?
To Next Page
Loading...
