6.2 EPB
1. If the brake pad wears the brake pad sense line, the brake pad sense line will send
a signal to the onboard computer asking for replacing the brake pad. After replacing
the brake pad, you must reset the brake pad to clear the trouble code.
Otherwise, vehicle will continue to falsely notify the driver that the brake pads are in
need of replacement.
2. A reset must be performed in the following cases:
● The brake pad and brake pad wear sensor are replaced.
●
The brake pad indicator lamp is on.
● The brake pad sensor circuit is shorted.
●
The servo motor is replaced.
The operation guidelines of the EPB function are shown as below:
Step 1: Enter the EPB menu and choose relevant models according to the vehicle
being tested.
To Next Page
Loading...
