Xtool IP500-TLS - Throttle Matching; A;F Settings; Windows Initialization; Suspension System

55
Follow the prompt steps and complete the function.
Caution
● The ABS pump screw needs to be unscrewed.
● Brake fluid will be under pressure during this process. Secure the bleed hose and
open bleeder screws slowly.
● Some vehicles do not support automatic bleeding, but manually bleeding.
6.8 Throttle Matching
Also called Throttle Reset or Throttle Match. This function enables you to reset the
throttle actuators and the learned values stored on ECU to the default state. Doing
so can accurately control the actions of regulating throttle (or idle engine) to adjust
the amount of air intake.
6.9 A/F Settings
This function is to reset or relearn the air/fuel ratio parameters.
6.10 Windows Initialization
When the vehicle battery is disconnected, the windows may not work right. This
function is used to perform door window matching to recover the ECU initial
memory, and recover the automatic ascending and descending function of power
window.
6.11 Suspension System
This function can adjust the vehicle body height sensor for level calibration after
replacing the vehicle height sensor or control module in the air suspension system,
or when the vehicle level is not correct.