Message of "Function execution is completed" displayed when SAS reset function
has been successfully completed.
6.4 BMS Reset
The Battery Management System (BMS) allows the Diagnostic Tool to evaluate the
battery charge state, monitor the close-circuit current, register the battery
replacement and activate the rest state of the vehicle.
This function enables you to perform a resetting operation on the monitoring unit of
the vehicle battery, in which the original low battery fault information will be cleared
and battery matching will be performed.
Battery matching must be performed in the following cases:
ā The main battery is replaced. Battery matching must be performed to clear original
low battery information and prevent the related control module from detecting
false information. If the related control module detects false information, it will
invalidate some electric auxiliary functions, such as automatic start & stop
function, sunroof without one-key trigger function or power window without
automatic function.
To Next Page
Loading...
