HeiTel by Xtralis ipVG Product Guide
29794_00 61
Continuous recording For all video inputs:
Use easy mode = activated; Recording image every = 1 second;
Preset for non-easy mode:
Contact status Closed:
Rec. method/trigger = Off; Recording interval (s) = 1; Number of images = 1
Contact status Opening (Edge +):
Rec. method/trigger = Off; Recording interval (s) = 1; Number of images = 10
Contact status Open:
Rec. method/trigger = Permanent; Recording interval (s) = 1;
Number of images = 1
Contact status Closing (Edge –):
Rec. method/trigger = Off; Recording interval (s) = 1; Number of images = 10
General Settings Part 2/2
Audio Listening = activated (selected source: Microphone); Speaking = activated
Relay Relay 1:
Name = Relay 1; Mode = Latch; Closed while idle = not activated;
Reset offline = activated; Closed= 10 s (preset for momentary mode)
PTZ control No PTZ protocol assigned; Deactivate PTZ = not activated
Serial channel Baud rate = 9600; Mode = 8/N/1 (8 data bits, no parity, 1 stop bit);
Function = Transparent
Alarm panel Connection in accordance with VdS 2465 S3:
For all options – including the submenus: not activated
Port=6666
Extras
Logfile Last caller = not activated; Change of inputs = not activated;
Only when armed = not activated; Temperature = activated;
Video signal loss detection = not activated
Service Alarm call in case of reboot = not activated;
Alarm call in case of defective Hard Disk = activated;
Routine call every 24 hours = not activated (time preset: 12:00);
Extra Use without hard disk drive = not activated;
Hang-up and redial on alarm = not activated;
Release access for PTZ, Relay, Audio after [] seconds = 60;
Preemption = activated;
Software video signal lost detection = Immediately
Merge into images Merge camera names into images = not activated;
Merge transmitter name into images = not activated
Service
Upload / Download File name=not defined
Firmware update Update device with file = not activated
To Next Page
Loading...
General