VX-6E OPERATING MANUAL 95
Set Mode Item 25
[
EDG.BEP
]
Function: Enables/Disables the Band-edge Beeper while selecting the frequency via the
DIAL knob.
Available Values: OFF/ON
Default: OFF
Set Mode Item 26
[
EMG S
]
Function: Selects the alarm(s) utilized when the Emergency function is engaged.
Available Values: BP+STR/BEAM/BP+BEM/CW/BP+CW/BEEP/STROBE
Default: BP+STR
BP+STR: Loud “Alarm” sounds and the TX/BUSY indicator flashes.
BEAM: The TX/BUSY indicator glows continuously in white.
BP+BEM: Loud “Alarm” sounds and the TX/BUSY indicator glows continuously in white.
CW: Transmits the Morse Code “SOS” (• • •
– – –
• • •) message on the air begin-
ning one minute after activation of the Emergency function.
BP+CW: Loud “Alarm” sounds and the Morse Code “SOS” (• • •
– – –
• • •) message is
transmitted on the air beginning one minute after activation of the Emergency
function.
BEEP: Loud “Alarm” sounds.
STROBE: The TX/BUSY indicator lamp flashes.
When the radio is set to the CW or BP+CW mode, the radio will be instructed to send “DE
(your callsign)” after the sending of the SOS message, if your callsign is entered via Set
Mode Item 14:
CW IDCW ID
CW IDCW ID
CW ID.
Set Mode Item 27
[
HLF.DEV
]
Function: Reducing the Deviation level by 50 %.
Available Values: OFF/ON
Default: OFF
Set Mode Item 28
[
HM/RV
]
Function: Selects the Primary function of the
[
HM/RV
(
EMG
)
R/H
]
key.
Available Values: REV/HOME
Default: REV
REV: Pressing the
[
HM/RV
(
EMG
)
R/H
]
key reverses the transmit and receive frequen-
cies during repeater operation.
HOME: Pressing the
[
HM/RV
(
EMG
)
R/H
]
key instantly recalls a favorite “Home” chan-
nel.
Set Mode Item 29
[
INT CD
]
Function: Selects the Access Number (DTMF digit) for WIRES
TM
operation.
Available Values: DTMF 1 - DTMF F
Default: DTMF 1
SET
(
MENU
)
M
ODE
To Next Page
