EasyManua.ls Logo

Yaesu VX-6E - Memory Recall and Labeling

Yaesu VX-6E
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VX-6E OPERATING MANUAL 35
4. Press and hold in the PTT switch, then press the
[
F/W
]
key once more momentarily
while holding the PTT switch in (this does not key the transmitter).
Whenever you recall a memory which contains inde-
pendently-stored transmit and receive frequencies, the
“ ” indication will appear in the display.
MEMORY RECALL
1. While operating in the VFO mode, press the
[
V/M
(
DW
)
MT
]
key
to enter the Memory mode.
2. Rotate the DIAL knob to select the desired channel.
3. To return to the VFO mode, press the
[
V/M
(
DW
)
MT
]
key.
When the radio is already set to the Memory mode, an easy way to recall memories is to
key in the memory channel number, then press the
[
V/M
(
DW
)
MT
]
key.
For example, to recall memory channel #14, press
[
1
]
Æ
[
4
]
Æ
[
V/M
(
DW
)
MT
]
.
You may also recall Memory Channel #000 and Programmable Memory channels (“L01/
U01” through “L50/U50”) using the following numbers: Memory Channel #000 = “1000,”
Programmable Memory channels #L1 = “1001,” U1 = “1002,” L50 = “1099,” and U50 =
“1100.” In these case, you do not need to press the
[
V/M
(
DW
)
MT
] key.
LABELING MEMORIES
You may wish to append an alpha-numeric “Tag” (label) to a memory or memories, to aid
in recollection of the channel’s use (such as a club name, etc.). This is easily accomplished
using the Set Mode.
1. Recall the memory channel on which you wish to append a label.
2. Press the
[
F/W
]
key, then press the
[
0
(
SET
)]
key to enter the
Set mode.
3. Rotate the DIAL knob to select Set Mode Item 40:
NM SETNM SET
NM SETNM SET
NM SET.
4. Press the
[
0
(
SET
)]
key momentarily to enable programming of
the name tag.
5. Rotate the DIAL knob to select the first digit of the desired label.
6. Press the
[
MODE
(
SP S
)
SQ TYP
]
key to move to the next char-
acter.
7. If you make a mistake, press the
[
BAND
(
SCN
)
BND DN
]
key
to back-space the cursor, then re-enter the correct letter, number,
or symbol.
8. Repeat steps 5 through 7 to program the remaining letters, numbers, or symbols of the
MEMORY STORAGE
MEMORY MODE
(
REGULAR MEMORY CHANNEL
)

Table of Contents