Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MODX Reference Manual
Common/Audio Edit
Common/Audio
General
Audio In
Mixing
Routing
Ins A
Ins B
EQ
Motion Seq
Common
Lane
Control
Control Assign
Control Number
Effect
Routing
Variation
Reverb
Master FX
Master EQ
USB Monitor
163
Reference
Side Chain/Modulator (Side Chain/Modulator Part)
Determines the Part used for the Side Chain/Modulator.
This is not available depending on the Effect Type.
For details on the Side Chain/Modulator, see the Routing display of the Normal Part (AWM2) (page 76).
Settings: Part 1–16, A/D, Master, Off
Ins Connect (Insertion Connection Type)
Determines the effect routing for Insertion Effects A and B. The setting changes are shown on the diagram
in the display, giving you a clear picture of how the signal is routed. For details, see the section “Effect
connection” (page 20) of the “Basic Structure.”
Settings: Ins AB, Ins BA
Rev Send (Reverb Send)
Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the
Reverb effect. This is available only when “Part Output” is set to “MainL&R” and “Global A/D” is set to
“OFF.”
Settings: 0–127
Var Send (Variation Send)
Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the
Variation effect. This is available only when “Part Output” is set to “MainL&R” and “Global A/D” is set to
“OFF.”
Settings: 0–127
Envelope Follower
Calls up the Envelope Follower setting display. For details, see the Routing display (page 76) of Normal
Part (AWM2) Edit. This is available only when “Part Output” is set to “MainL&R.”
Output Select (Part Output Select)
Determines specific audio output.
Settings: MainL&R, USB1&2…USB7&8, AsgnL, USB1…USB8, Off
MainL&R: Outputs in stereo (two channels) to the OUTPUT [L/MONO]/[R] jacks.
USB1&2…USB7&8: Outputs in stereo (Channels 1&2–7&8) to the [USB TO HOST] terminal.
USB1…USB8: Outputs in mono (Channels 1–8) to the [USB TO HOST] terminal.
Off: No audio signal for the Part is output.
Same as the Element Common Edit parameters for Normal Parts (AWM2) (page 77).
Same as the Element Common Edit parameters for Normal Parts (AWM2) (page 78) except that “3-band
EQ” is inactive.
Ins A (Insertion Effect A)
Ins B (Insertion Effect B)
EQ (Equalizer)
To Next Page
Loading...
