Yamaha SRCP - Page 191

11-15
11
11-5 Communication Command Description
COMMUNICATION WITH PC
(21) @CSEL <array element number>
Specifies an array element for the counter array variable C to be used.
Array element number : This is a number used to designate an array element for the
counter array variable C, and can be from 0 to 31. The counter
variable D can also be specified here as the array element.
Transmission example : @CSEL 1 c/r l/f ............................ Uses the counter array variable
C of element number 1 in the
subsequent steps.
Response example : OK c/r l/f
(22) @C <counter value>
Sets a specified value in the counter array variable C specified with the CSEL statement.
Counter value : This can be any value from 0 to 65535.
Transmission example : @C 100 c/r l/f ............................... Sets the counter array variable
C to 100.
Response example : OK c/r l/f
(23) @C+ [<addition value>]
Adds a specified value to the counter array variable C.
Addition value : This can be any value from 1 to 65535. If this value is omitted,
then 1 is added to the counter array variable.
Transmission example : @C+ c/r l/f ................................... Increments the counter array
variable C. (C ← C+1)
Response example : OK c/r l/f
(24) @C- [<subtraction value>]
Subtracts a specified value from the counter array variable C.
Subtraction value : This can be any value from 1 to 65535. If this value is omitted,
then 1 is subtracted from the counter array variable.
Transmission example : @C- c/r l/f .................................... Decrements the counter array
variable C. (C ← C-1)
Response example : OK c/r l/f
(25) @D <counter value>
Sets a specified value in the counter variable D.
Counter value : This can be any value from 0 to 65535.
Transmission example : @D 100 c/r l/f .............................. Sets the counter variable D to
100.
Response example : OK c/r l/f