Periodic maintenance and adjustment
8-6
8
12 * Tires
• Check tread depth and for dam-
age.
• Replace if necessary.
• Check air pressure.
• Correct if necessary.
√√√√√
13 * Wheel bearings
• Check bearing for looseness or
damage.
√√√√
14 * Drive belt
• Check belt condition.
• Replace if damaged.
• Check belt tension.
• Adjust if necessary.
At the initial interval and every 10000 km (6000 mi) until 40000 km (24000 mi),
and every 5000 km (3000 mi) thereafter.
15 *
Drive pulley and
drive axle
• Lubricate. √√
16 * Steering bearings
• Check bearing assemblies for
looseness.
√√ √
• Moderately repack with lithium-
soap-based grease.
√√
17 * Chassis fasteners
• Make sure that all nuts, bolts and
screws are properly tightened.
√√√√√
18
Front and rear
brake lever pivot
shaft
• Lubricate with silicone grease. √√√√√
19 *
Sidestand, center-
stand
• Check operation.
• Lubricate with lithium-soap-
based grease.
√√√√√
20 * Sidestand switch
• Check operation and replace if
necessary.
√√√√√√
NO. ITEM CHECK OR MAINTENANCE JOB
ODOMETER READING
ANNUAL
CHECK
1000 km
(600 mi)
10000 km
(6000 mi)
20000 km
(12000 mi)
30000 km
(18000 mi)
40000 km
(24000 mi)
UB3TE0E0.book Page 6 Tuesday, September 17, 2019 9:35 AM
To Next Page
Loading...
