3 - 31
CHK
ADJ
CHANGING THE ENGINE OIL
3. Remove:
• engine oil filler cap 1
• engine oil drain bolt 2
(along with the gasket)
4. Drain:
• engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be
replaced, perform the following procedure.
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the oil filter cartridge 1 with an oil
filter wrench 2.
b. Lubricate the O-ring 3 of the new oil filter
cartridge with a thin coat of engine oil.
CAUTION:
Make sure that the O-ring is positioned cor-
rectly in the groove of the oil filter car-
tridge.
c. Tighten the new oil filter cartridge to specifi-
cation with an oil filter wrench.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
6. Check:
• engine oil drain bolt gasket
Damage → Replace.
7. Install:
• engine oil drain bolt
(along with the gasket)
Oil filter wrench
90890-01469
T
R
.
.
Oil filter cartridge
17 Nm (1.7 m · kg, 12 ft · lb)
3
T
R
.
.
43 Nm (4.3 m · kg, 31 ft · lb)
To Next Page