1 - 22
GEN
INFO
SPECIAL TOOLS
EAS00027
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
NOTE:
• For U.S.A. and Canada, use part number starting with “YM-”, “YU-”, or “ACC-”.
• For others, use part number starting with “90890-”.
Tool No. Tool name/Function Illustration
90890-01235
YU-01235
Rotor holding tool
This tool is used to hold the clutch
assembly.
90890-01268
YU-01268
Ring nut wrench
This tool is used to loosen or tighten the
steering ring nuts.
90890-01304
YU-01304
Piston pin puller set
This tool is used to remove the piston
pins.
Radiator cap tester
90890-01325
YU-24460-01
Radiator cap tester
adapter
90890-01352
YU-33984
Radiator cap tester
Radiator cap tester adapter
These tools are used to check the cooling
system.
T-handle
90890-01326
YM-01326
Damper rod holder
90890-01294
YM-01300
T-handle
Damper rod holder
These tools are used to hold the damper
rod when removing or installing the
damper rod.
90890-01348
YM-01348
Locknut wrench
This tool is used to remove or install the
secondary sheave spring seat nut.
To Next Page
Loading...
