6 - 15
COOL
WATER PUMP
5. Measure:
• tilt
Out of specification → Repeat steps (3) and
(4).
CAUTION:
CAUTION:
Make sure that the rubber damper and rub-
ber damper holder are flush with the impel-
ler.
1
Straightedge
2
Impeller
Maximum impeller shaft tilt
0.15 mm (0.006 in)
INSTALLING THE WATER PUMP
1. Install:
• water pump assembly
NOTE:
NOTE:
Align the projection a at the oil pump shaft
and water pump shaft groove b.
2. Fill:
• cooling system
(with the specified amount of the recom-
mended coolant)
Refer to “CHANGING THE COOLANT” in
chapter 3.
3. Check:
• cooling system
Leaks → Repair or replace any faulty part.
4. Measure:
• radiator cap opening pressure
Below the specified pressure → Replace
the radiator cap.
Refer to “CHECKING THE RADIATOR”.
LS
b
a
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
To Next Page