2 - 55
SPEC
CABLE ROUTING
Î Make sure that brake pipe touches the projec-
tion.
Ï Make sure that the slot in the speed sensor fits
stopper on the outer tube.
Ð Make sure that the stopper touches the outer
tube stay.
Ñ Pass the speed sensor lead between the brake
hose and front fork.
Ò Fasten the speed sensor lead to the center of
brake hose holder.
Ó Install the hose holder to the innermost securely.
Ô Engage the hose holder rib more than 3 notch.
Face the hose holder projection to the back.
Õ Make sure that the white paint on the brake hose
faces to back (right side only).
Ö Install the stopper to the stay 1.
× Fasten the front brake hose and rear brake hose
with a hose holder.
Ø Make sure that the brake hose joint touches the
projection of the outer tube.
Ù Make sure that the brake hose holder touches
the projection of the outer tube.
A
B
C-C
D-D
D
D
C
C
Ö
×
Õ
Ó
Ô
Ò
Ð
Ï
Î
Í
Ì
Ñ
Ë
Ê
É
È
Ì
È
Ø
Ö
4
5
3
2
Ù
1
A
B
1
2
6
7
9
2
7
2
9
7
8
Left sideRight side
To Next Page