5. User parameters
5-1. About user parameters
The Scalapro
™
allows you to change the settings to best fit for your needs and applications. Change the
settings as needed, referring to the upcoming user parameter table.
5-2. How to set a user parameter
Operation Display
Press
and at the same time.
The panel shows the user parameter #01 and its setting.
Use the following keys when you set a user parameter.
Switches to the next
parameter.
Increases the parameter setting by 1
&
Returns to the previous
parameter.
Decreases the parameter setting by 1.
[IMPORTANT]
When you have changed a setting, be sure to press
to switch to the next parameter before
turning off the power.
Unless you switch to the next parameter, any changes you made to the setting will be lost.
5-3. User parameter table
Number Item
Setting
value
Description of options
(The underlined option is the factory setting.)
#01 Checkweighing function 0: Disable the checkweighing function
1: Simplified checkweighing function
2:
Inspection checkweighing function
(The upper and lower limits are set using the measured weight of a
sample as the middle value.)
#03 LED lighting timing 0:
Disable LED
(parameter for multi-function) 1:
LED ON upon underweight
2:
LED ON upon proper weight
3:
LED ON upon overweight
4:
LED ON upon underweight and flashes upon overweight
#05 Automatic power OFF time 0:
Disable automatic power OFF function
1:
5 minutes
2:
10 minutes
3:
15 minutes
4:
30 minutes
5: 60 minutes
#07
Flashing of indicated value per
evaluation
0:
Disable flashing
(parameter for checkweighing
function)
1: Flash upon underweight
2: Flash upon proper weight
3: Flash upon overweight
4: Flash upon underweight or overweight
5: Synchronize with #03 (LED lighting timing)
To Next Page
Loading...
Need help?
General
