7-3. Gravitational acceleration compensation for the region of use
(only for a scale not legal for trade)
Carry out the following procedure to compensate for gravitational acceleration by the region of use. Refer to
the setup value of the gravitational acceleration by the region of use.
*1 Once this compensation is made, there is no need to do it again the next time. Simply turn on the power
and use the instrument.
*2 If you use a compensated instrument in an area with a different setup value, you need to compensate
again for the gravitational acceleration corresponding to the region of use.
Gravity compensation for the region of use
[Example] If you use the instrument in Bangkok, Thailand (Gravitational acceleration: 9.783 m/s
2
):
Formula: (9.783 - 9.7600) × 10000 ÷ 5 + 30 = 76; therefore, the setup value is “76”
Operation Display
Press
and at the same time to enter the user
parameter
setting mode, and call the parameter #09.
Set it to “76” and then press
.
Then the next parameter #22 appears.
Hold down
to turn off the power.
This completes the setting for the region of use.
To Next Page
Loading...
Need help?
General
