8. Other topics
8-1. Error messages
The following messages appear in the event of an error. Take the corresponding actions specified in the table.
If any codes other than the following appear or if the error still persists even after taking the following actions,
contact your vendor.
Message Cause Action
Low battery
The batteries are running out.
Replace all the batteries with new ones.
Do not use a new battery together with an
old battery or an alkaline battery together
with a manganese battery.
Battery is dead
The batteries have run out.
Replace all the batteries with new ones.
Do not use a new battery together with an
old battery or an alkaline battery together
with a manganese battery.
Low voltage
The voltage from the AC adaptor
is significantly low.
The AC input voltage is low.
After the shutdown, plug it in to another
outlet. Then turn it on again.
Unable to weigh
Measured weight is less than the
value of 5 scale intervals.
Press the Zero Reset key. If the platform
cover is removed, place it again.
Unable to weigh
Measured weight is more than
[the weighing capacity + 5 scale
intervals].
Remove the item(s), which returns to
measuring mode. Use the instrument
within the weighing capacity.
Unable to weigh
This code may appear when you
turn on the power with a heavy
item put on the weighing
platform.
Turn on the power with nothing put on the
platform.
Unable to weigh
This code may appear when you
turn on the power with something
caught between the weighing
platform and the platform cover.
Check that nothing is caught between
them. In addition, check that no items are
in contact with the platform cover, and then
press the Zero Reset key.
Unable to weigh
This code may appear when you
press the Zero Reset key with a
heavy item put on the weighing
platform.
The item weighs more than the limit of zero
reset. Remove the item, and then press
the Zero Reset key.
Unable to weigh
This code may appear when you
turn on the power with something
put on the weighing platform,
remove it, and then press the
Zero Reset key.
Turn on the power with nothing put on the
weighing platform.
To Next Page
Loading...
Need help?
General
