C.2 European Standards
Figure C.1 CE Mark
The CE
mark indicates compliance with European safety and environmental regulations and
is required for engaging in business and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low
Voltage
Directive for electronics manufacturers and the EMC guidelines for controlling noise.
This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive.
• EMC Guidelines: 2004/108/EC
• Low Voltage Directive: 2006/95/EC
u
CE Low Voltage Directive Compliance
This drive has been tested according to IEC61800-5-1:2007, and it fully complies with the
Low Voltage Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when
combining this drive with other devices:
n
Area of Use
Do not
use drives in areas with pollution higher than severity 2 and overvoltage category 3 in
accordance with IEC664.
n
Installing Fuses on the Input Side
Always install input fuses that comply with UL standards to prevent the drive from short
circuits. Refer to Factory Recommended Drive Branch Circuit Protection on page 251 for
the appropriate fuse based on the maximum input of the drive. Refer to Heavy Duty and
Normal Duty Ratings on page 198 for information on drive input and output currents.
n
Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If installing the
drive in other types of grounded systems, contact your dealer or Yaskawa for instructions.
C.2 European Standards
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
241
C
Standards Compliance
To Next Page
Loading...
Need help?
General
