Step Display/Result
3.
Press the key to view the parameter setting display.
4.
Scroll through parameters by pressing the key until C1-01
appears.
5.
Press
to view the current setting value (10.0). (Number
farthest to the left flashes)
6.
Press
until the desired number is selected. (“1” flashes)
7.
Press the key and enter 0020.0.
8.
Press
and the drive will confirm the change.
9. The display automatically returns to the screen shown in Step 4.
10.
Press the key until back at the initial display.
u
Verifying Parameter Changes: Verify Menu
The Verify Menu lists edited parameters from the Programming Mode. The Verify Menu
helps determine
which settings have been changed, and is particularly useful when replacing
a drive. If no settings have been changed the Verify Menu will read
. The Verify menu
also allows users to access and re-edit edited parameters.
Note: The Verify Menu will not display parameters from the A1 group even if those parameters have been
changed from default settings.
The following
example is a continuation of the steps beginning on page 83. Here, parameter
C1-01 is accessed using the Verify Menu and is changed again to 20.0 s.
To check the list of edited parameters:
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
2.
Press until the display shows the “Verify” representation.
4.3 The Drive and Programming Modes
84
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
To Next Page
Loading...
