YASKAWA GPD315/V7-4X User Manual

B. Copy Function (Cpy)
The Copy function writes the parameters stored in the digital operator’s EEPROM into the drives
non-volatile memory.The Copy function is possible only for drives of the same type (i.e. from one
GPD 315/V7 to another), voltage rating, and control method (V/f or open loop vector).
5.29 COPY FUNCTION
5-48
DIGITAL OPERATOR
DESCRIPTION KEY SEQUENCE DISPLAY
Table 5-6. Writing Drive Parameters
Set the highest parameter
access level.
This will allow all parameters
to be viewed and set.
Press the key until the LED
is lit on the digital operator.
DSPL
Set Parameter Copy
Access Selection (n177) = 1
Press and hold until n177 is
displayed on the digital operator.
V
Execute upload (Copy)
Using Copy Function
Selection (n176)
PRGM
Then press .
DATA
ENTER
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
Use the key to set a “1” in the
display.
V
Then press .
DATA
ENTER
Then press .
DATA
ENTER
Press .
DATA
ENTER
Press three times.
V
Press .
DATA
ENTER
Press the key once.
V
Press the key twice.
V
Press . “CPY” will blink on the
display while writing.
DATA
ENTER

YASKAWA GPD315/V7-4X Specifications

General

Brand	YASKAWA
Model	GPD315/V7-4X
Category	DC Drives
Language	English