6 Mechanical Installation
20 YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation
Remove the Front Cover
1. Remove the keypad from the drive.
A - Keypad
Figure 6.8 Remove the Keypad
2. Loosen the front cover screw.
Figure 6.9 Loosen the Front Cover Screw
3. Push on the tabs in the sides of the front cover then pull the front cover forward to remove it from the drive.
Figure 6.10 Remove the Front Cover
Reattach the Front Cover
1. Wire the drive and other peripheral devices.
2. Reverse the steps to reattach the cover.
Note:
• Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
• Make sure that the tabs on the sides of the front cover correctly click into the hook.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 in∙lb to 11.77 in∙lb).
To Next Page
Loading...
