– Additional apps can have a negative impact on real-time behavior.
– Please note that a licence may be required for installation or use.
To install an app, proceed as follows:
1. Click at [Install App].
2. In the file explorer that opens, select the app (*.app) to be installed.
3. Click at [Open].
ð
The selected app container is now sent to the controller and installed. After suc-
cessful installation, the app is listed in the Installed iCube Apps table.
To start an app, click in the table ‘Installed iCube Apps’ at [Start] behind the corre-
sponding app.
ð
The app is started and the app status ‘RUN’ in the column ‘App Status’ is
shown.
Please note that starting multiple apps may require a CPU
restart. You will be informed of the impending restart by a dialog
that opens.
To quit an app, click in the table ‘Installed iCube Apps’ at [Stop] behind the corre-
sponding app.
ð
The app is quit and the app status ‘Stop’ in the column ‘App Status’ is shown.
1. To uninstall an app, you must quit it first. To do this, click in the table ‘Installed
iCube Apps’ at [Stop] behind the corresponding app.
2. To uninstall, click the following in the table ‘Installed iCube Apps’ at [Uninstall]
behind the corresponding app.
ð
After a security prompt, the corresponding app is uninstalled.
Installing an app
Starting an app
Quit an app
Uninstalling an app
iC9200 Series
Deployment
Web-based management - WBM > Administration
HB700 | CPU | PMC921xEx | en | 23-06 108
To Next Page
Loading...
