4.4.3 Create a new project
1. Start iCube Engineer.
2. On the start bar, click on a project template that corresponds to your firmware ver-
sion, such as Yaskawa CPU iC921xM-x
ð
The project template for a blank CPU iC921xM-x opens.
3.
Open ‘File è Save Project As’, assign a meaningful name to your project and close
the dialog with [Save].
4.4.4 Online access to the CPU
On delivery the following IP address parameters for the communication are preset in the
project template of the CPU:
n Ethernet-Port (X3/X4): 192.168.1.1
n Subnet mask: 255.255.255.0
n Gateway: -
If your CPU has different IP address parameters, you can adapt them for iCube Engineer
via the following procedure:
1. In the ‘Plant’ area, double-click the CPU node
ð
The CPU editor group opens.
2. Select the ‘Settings’ editor.
Proceeding
IP address parameters for
communication
iC9200 Series
Deployment
Commissioning > Online access to the CPU
HB700 | CPU | PMC921xEx | en | 23-06 64
To Next Page
Loading...
