Specify the filter settings. By clicking on [ Apply Filter ], the previously made filter settings
are activated and the table with the message entries is refreshed accordingly.
There are the following filter options:
n Archive name
– Here you can filter the message entries by specifying an archive name.
n Severity
– Here you can limit the message entries based on their severity.
– The limitation is based on the following graduation for the minimum severity:
Internal à Information à Warning à Error à Critical Error à Fatal Error
For example with Internal, all degrees of severity are listed. With the setting Error,
all Error, Critical Error and Fatal Error are listed.
n Sender
– Here you can limit the message entries by entering or selecting a sender in the
selection field.
– The currently list of message entries is always decisive for the names in the
selection field.
– When entering a name or part of the name, click on [Apply Filter] to list messages
from senders that match or partially match the name you are looking for.
n Maximum number of notifications
– Here you can limit the number of message entries to be listed.
– 1024 is set by default, a maximum of 4000 is allowed.
n Time from, Time to
– Here you can limit the period of the message entries by entering the date and
time.
– Time from: Lists all message entries that are not older than the specified time.
– Time to: Lists all message entries that are older than the specified time.
– When filtering by time specification, a date must always be entered and a time
can be added.
Filter functions
iC9200 Series
Deployment
Web-based management - WBM > Diagnostics
HB700 | CPU | PMC921xEx | en | 23-06 79
To Next Page
Loading...
