Date and Time
Configuration
Configuration
Network
Date and Time
System Services
Web Services
Information
Diagnostics
Security
Administration
iC92...
PMC92...
Here you can configure the NTP client by adding new NTP server entries.
1.
To do this, click below the table on .
ð
The dialog for adding an NTP server opens.
2. Enter the according parameters.
n Server Host Name
– Enter the address at which the NTP server can be reached in the network.
n Comment
– Here you can assign an internal designation for the NTP server.
n The other parameters are for information and cannot be changed.
3. Click at [OK].
ð
The dialog is closed and the NTP server is listed in the table.
You can remove entries with and edit them with .
4. Click on [Apply].
ð
You will receive a message that applying the new NTP daemon configuration
requires a restart of the NTP daemon and that this may lead to a real-time viola-
tion. With [OK], the NTP servers listed in the table are accepted for time-of-day
synchronization and the NTP daemon is restarted.
4.9.4.3 System Services
Here you can find status information about the enabled and disabled system services, as
well as their factory default settings. You can increase the efficiency of your system by
deactivating services that are not required.
iC9200 Series
Deployment
Web-based management - WBM > Configuration
HB700 | CPU | PMC921xEx | en | 23-06 87
To Next Page
Loading...
