YASKAWA MOTOMAN-MFL15D-875 - Grease Replenishment for U-Axis Cross Roller Bearing

9-15
179394-1CD
HW1483905
9 Maintenance and Inspection
9.3 Grease Exchange Procedures
MFL15D-875/-1600
9.3.4 Grease Replenishment for U-Axis Cross Roller Bearing
Fig. 9-7: U-Axis Cross Roller Bearing
1. Remove the hexagon socket head plugs PT1/8 on the Uco exhaust
port and the Uci grease inlet.
2. Install grease zerk A-PT1/8 on the Uci grease inlet, then inject grease.
(Refer to Fig. 9-7 “U-Axis Cross Roller Bearing”.)
3. Reinstall the hexagon socket head plug PT1/8 on the Uco exhaust
port. Apply ThreeBond 1206C to the thread parts.
4. Reinstall the hexagon socket head plug PT1/8 on the Uci grease inlet.
Apply ThreeBond 1206C to the thread parts.
Cross roller bearing
Link
Uco: Exhaust port
Hexagon socket head plug PT1/8
Uci : Grease inlet
Hexagon socket head plug PT1/8
Grease Type: Alvania EP Grease 2
Amount of Grease: 8 g (16 g for 1st supply)
Use a manual grease gun
NOTE
Grease is not exhausted from the Uco exhaust port. Do not
inject excessive grease.
67 of 74