1.2Installation
— 1-9 —
1.2.3 Installing the Servopack
The SGDF Servopack is a book-shaped compact ser-
vo controller.
Incorrect installation will cause malfunctions. Always
observe the following precautions when installing the
Servopack.
Storage:
When the Servopack is to be stored with the pow-
er cable disconnected, store it within the following
temperature range:
Between −20 °C and 85 °C
Installation Site
Situation Notes on Installation
Installed in a control panel
Design the control panel size, Servopack layout, and
cooling method so that the ambient temperature of the
Servopack does not exceed 50
°
C.
Installed near a heating unit
Suppress radiation heat from the heating unit and a rise
in temperature caused by convection so that the ambient
temperature of the Servopack does not exceed 50
°
C.
Installed near a source of
vibration
Install a vibration isolator underneath the Servopack to
prevent it from receiving vibration.
Installed in a place subject to
corrosive gases
Corrosive gases do not immediately affect the Servopack
but will eventually cause contactor-related devices to
malfunction. Take appropriate action to prevent corrosive
gases.
Others
Do not install in a hot and humid place or where
excessive dust or iron powder is present in the air.
Orientation:
Install the Servopack perpendicular to the wall as
shown in the figure.
The Servopack must be orientated as shown in
the figure because it is designed to be cooled by
natural convection.
• Firmly secure the Servopack to the mounting
surface through the mounting holes.
1
SGDF Servopack
SGDF-
A1CS
DC24V
CN3
C
N
5
CN4
CN1/IO
CN2/PG
SERVOPACK
RDY
ALM
Ventilation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
