APPLICATIONS
2.2.1 Speed Referencescont.
— 2-10 —
Parameter Cn-03 can be used to change the voltage input range.
Example of Input Circuit
The adjacent diagram shows an example of an input
circuit.
For noise control, always use twisted-pair cable.
Recommended Variable Resistor for Speed Setting:
Type 25HP-10B manufactured by Sakae Tsushin Kogyo Co., Ltd.
When position control is performed by a host control-
ler such as a Programmable Controller, connect V-
REF and SG to speed reference output terminals on
the host controller. In this case, adjust Cn-03 accord-
ing to output voltage specifications.
Use the memory switch and input signal /P-CON to specify one of the four modes shown be-
low.
Cn-01 Bit A
Control Mode Selection Factory
Setting: 0
For Speed/Torque Control
Cn-01 Bit B
Control Mode Selection Factory
Setting: 0
For Speed/Torque Control
The Servopack for speed/torque control provides three different control modes.
2
Servopack
CN1-12
CN1-13
SG
V-REF
470 Ω, 1/2 W or more
2kΩ
+12V
: Twisted-pair cable.
CN1-12
CN1-13
CN1-14
CN1-15
CN1-16
CN1-17
SG
V-REF
/PBO
PBO
/PAO
PAO
Host controller
Servopack
Feedback
pulse input
terminals
Speed
reference
output
terminals
: Twisted-pair cable.
Speed/Torque
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
