Parameter overview
Operating parameters Description Assignment
Main count direction
n None No restriction of the counting range
n Up: Restricts the up-counting range. The counter starts
from 0 or load value, counts in positive direction up to
the declaration end value
-1 and then jumps back to
load value at the next positive transducer pulse.
n Down: Restricts the down-counting range. The counter
starts from the declared start value or load value in
negative direction, counts to 1 and then jumps to start
value at the next negative encoder pulse. Function is
disable with count continuously.
n None
Gate function
n Cancel count:
The count starts when the gate opens
and resumes at the load value when the gate opens
again.
n Stop count: The count is interrupted when the gate
closes and resumed at the last actual counter value
when the gate opens again.
Ä
Chapter 5.6.6.2 ‘Gate function’ on page 111
Abort count process
Start value
End value
Start value with counting direction backward.
End value with main counting direction forward.
Range of values: 2...2147483647 (2
31
-1)
2147483647 (2
31
-1)
Comparison value The count value is compared with the comparison value.
See also the parameter "Characteristics of the output":
n No main counting direction
–
Range of values: -2)
31
to +2)
31
-1
n Main counting direction forward
– Range of values: -2
31
to end value-1
n Main counting direction backward
– Range of values: 1 to +2
31
-1
0
Hysteresis The hysteresis serves the avoidance of many toggle pro-
cesses of the output, if the counter value is in the range of
the comparison value.
0, 1: Hysteresis disabled
Range of values: 0 to 255
0
VIPA System MICRO
Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Counter
HB400 | CPU | M13-CCF0000 | en | 16-47 191
To Next Page
Loading...
