Parameter overview
Operating parameters Description Assignment
Integration time Specify the integration time
Range of values: 10ms ... 10000ms in steps of 1ms
100ms
max. counting frequency... Specify the max. Frequency for the corresponding input
Range of values: 1, 2, 5, 10, 30, 60, 100kHz
60kHz
Hardware interrupt Description Assignment
End of measurement Hardware interrupt at end of measurement de-activated
9.6.7 Pulse width modulation - PWM
9.6.7.1
Overview
n 2 channels
n Sub module ‘Count’
n
Ä
Chapter 5.8 ‘Pulse width modulation - PWM’ on page 123
9.6.7.2 Parametrization in SPEED7 Studio
9.6.7.2.1 ‘I/O addresses’
Sub module Input address Access Assignment
Count 816 DINT reserved
820 DINT reserved
824 DINT reserved
828 DINT reserved
Sub module Output address Access Assignment
Count 816 DWORD reserved
820 DWORD reserved
824 DWORD reserved
828 DWORD reserved
9.6.7.2.2 ‘Channel x:’
Select via ‘Channel’ the channel and select for pulse width modulation via ‘Operating
mode’ the operating mode ‘Pulse width modulation’ . Default values and structure of this
dialog box depend on the selected ‘Operating mode’ . The following parameters are sup-
ported:
Operating mode
VIPA System MICRO
Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Pulse width modulation - PWM
HB400 | CPU | M13-CCF0000 | en | 16-47 195
To Next Page
Loading...
