X5 Function Type LED Description
1 - - reserved
2 - - reserved
3 DI 1.0 I
green
Digital input DI 8
4 DI 1.1 I
green
Digital input DI 9 / Counter 3 (A) *
5 DI 1.2 I
green
Digital input DI 10 / Counter 3 (B) / Frequency 3 *
6 DI 1.3 I
green
Digital input DI 11 / Gate 3 *
7 DI 1.4 I
green
Digital input DI 12
8 DI 1.5 I
green
Digital input DI 13
9 DI 1.6 I
green
Digital input DI 14
10 DI 1.7 I
green
Digital input DI 15 / Latch 3 *
*) Max. input frequency 100kHz otherwise 1kHz.
5.4.3 Parametrization
5.4.3.1 Adress assignment
Sub module Input address Access Assignment
DI24/DO16 136 BYTE Digital input I+0.0 ... I+0.7 (X1)
137 BYTE Digital input I+1.0 ... I+1.7 (X5)
5.4.3.2 Hardware interrupt
With the parameter ‘Hardware interrupt at ...’ you can specify a hardware interrupt for
each input for the corresponding edge. The hardware interrupt is disabled, if nothing is
selected (default setting). A diagnostics interrupt is only supported with Hardware inter
-
rupt lost. Select with the arrow keys the input and enable the according hardware inter-
rupts.
Here is valid:
n Rising edge: Edge 0-1
n Falling edge: Edge 1-0
5.4.3.3 Input delay
n The input delay can be configured per channel in groups of 4.
n An input delay of 0.1ms is only possible with "fast" inputs, which have a max. input
frequency of 100kHz
Ä
Chapter 5.4 ‘Digital input’ on page 90. Within a group, the
input delay for slow inputs is limited to 0.5ms.
n Range of values: 0.1ms / 0.5ms / 3ms / 15ms
Parameter hardware con-
figuration
Parameter hardware con-
figuration
VIPA System MICRO
Deployment I/O periphery
Digital input > Parametrization
HB400 | CPU | M13-CCF0000 | en | 16-47 92
To Next Page
Loading...
