syslibex.wld n/a
Protect.wld n/a
ARM Processor Load
Measurement Cycle Time 100 ms
Last Value 79%
Maximum Load 100%
Currently nothing is displayed here.
Currently nothing is displayed here.
Here the IP address data of your Ethernet PG/OP channel are shown.
4.1
1 Operating modes
4.11.1 Overview
The CPU can be in one of 3 operating modes:
n Operating mode STOP
n Operating mode START-UP
(OB 100 - restart / OB 102 - cold start *)
n Operating mode RUN
Certain conditions in the operating modes START-UP and RUN require a specific reaction
from the system program. In this case the application interface is often provided by a call
to an organization block that was included specifically for this event.
n The application program is not processed.
n If there has been a processing before, the values of counters, timers, flags and the
process image are retained during the transition to the ST
OP mode.
n Command output disable (BASP) is activated this means the all digital outputs are
disabled.
n
: The yellow LED of the status bar lights up in the STOP state.
Data
Parameter
IP
Operating mode STOP
VIPA System MICRO
Deployment CPU M13-CCF0000
Operating modes > Overview
HB400 | CPU | M13-CCF0000 | en | 16-47 73
To Next Page
Loading...
