9. Plug again the wired connectors.
ð
Now you can bring your system back into operation.
2.6.2
Demounting the extension module
1. Power-of
f your system.
2. Remove the corresponding bus connectors.
3. Pull the locking levers of the extension module outwards until these engage
audible.
4. Remove the extension module from the CPU by sliding it on the mounting rail.
5. Remove the extension module with a rotation upwards from the mounting rail.
6. Pull the locking levers of the extension module outwards until these engage
audible.
CAUTION!
It is not allowed to mount the module sideways on the mounting rail,
as otherwise the module may be damaged!
7. Plug the extension module from the top onto the mounting rail and turn the exten-
sion module downward until it rests on the mounting rail.
Proceeding
VIPA System MICRO
Basics and mounting
Demounting > Demounting the extension module
HB400 | CPU | M13-CCF0000 | en | 16-47 26
To Next Page
Loading...
