YASKAWA VIPA System MICRO M13-CCF0000 - Page 240

Event ID Description
0x0021: Slave needs INIT
0x0022: Slave needs PreOp
0x0023: Slave needs SafeOp
0x002D: Invalid output FMMU configuration
0x002E: Invalid input FMMU configuration
0x0030: Invalid DC Sync configuration
0x0031: Invalid DC Latch configuration
0x0032: PLL error
0x0033: Invalid DC IO error
0x0034: Invalid DC timeout error
0x0042: Error in acyclic data exchange Ethernet over EtherCAT
0x0043: Error in acyclic data exchange CAN over EtherCAT
0x0044: Error in acyclic data exchange file access over EtherCAT
0x0045: Error in acyclic data exchange servo drive profile over EtherCAT
0x004F: Error in acyclic data exchange vendor specific over EtherCAT
DatID : Input address
DatID : Output address
DatID : Station not available
DatID : Station available
0xED23 EtherCAT: Timeout while changing the master status to OP, after CPU has changed to RUN
OB : Operation mode
0: Configuration in operation mode RUN
1: STOP (update)
2: STOP (overall reset)
3: STOP (own initialization)
4: STOP (internal)
5: Start-up (cold start)
6: Start-up (cold restart/warm start)
7: Start-up (restart)
8: RUN
9: RUN (redundant operation)
10: HALT
11: COUPLING
12: UPDATING
13: DEFECTIVE
14: Troubleshooting
15: Without power
0xFD: Process image enabled in STOP
VIPA System MICRO
System specific event IDs
HB400 | CPU | M13-CCF0000 | en | 16-47 240