YASKAWA VIPA System MICRO M13-CCF0000 - Page 247

SFB Name Description
SFB 49 PULSE Pulse width modulation
SFB 52 RDREC Read record set
SFB 53 WRREC Write record set
SFB 54 RALRM Receiving an interrupt from a periphery module
SFC Name Description
SFC 0 SET_CLK Set system clock
SFC 1 READ_CLK Read system clock
SFC 2 SET_RTM Set run-time meter
SFC 3 CTRL_RTM Control run-time meter
SFC 4 READ_RTM Read run-time meter
SFC 5 GADR_LGC Logical address of a channel
SFC 6 RD_SINFO Read start information
SFC 7 DP_PRAL Triggering a hardware interrupt on the DP master
SFC 12 D_ACT_DP Activating and deactivating of DP slaves
SFC 13 DPNRM_DG Read diagnostic data of a DP salve
SFC 14 DPRD_DAT Read consistent data
SFC 15 DPWR_DAT Write consistent data
SFC 17 ALARM_SQ ALARM_SQ
SFC 18 ALARM_SQ ALARM_S
SFC 19 ALARM_SC Acknowledgement state last alarm
SFC 20 BLKMOV Block move
SFC 21 FILL Fill a field
SFC 22 CREAT_DB Create a data block
SFC 23 DEL_DB Deleting a data block
SFC 24 TEST_DB Test data block
SFC 28 SET_TINT Set time-of-day interrupt
SFC 29 CAN_TINT Cancel time-of-day interrupt
SFC 30 ACT_TINT Activate time-of-day interrupt
SFC 31 QRY_TINT Query time-of-day interrupt
SFC 32 SRT_DINT Start time-delay interrupt
SFC 33 CAN_DINT Cancel time-delay interrupt
SFC 34 QRY_DINT Query time-delay interrupt
SFC 36 MSK_FLT Mask synchronous errors
SFC 37 MSK_FLT Unmask synchronous errors
SFC 38 READ_ERR Read error register
SFC 39 DIS_IRT Disabling interrupts
VIPA System MICRO
Integrated blocks
HB400 | CPU | M13-CCF0000 | en | 16-47 247