2. ... and move the modules accordingly
.
3. Remove the periphery module with a rotation upwards from the mounting rail.
4. Pull the locking levers outwards until these engage audible.
CAUTION!
It is not allowed to mount the module sideways on the mounting rail,
as otherwise the module may be damaged!
5. Plug the periphery module from the top onto the mounting rail and turn the
periphery module downward until it rests on the mounting rail.
6. Reconnect all modules by pushing them together again on the mounting rail.
7. Move the locking levers back to the initial position.
8. Remove the connectors, which are not necessary
.
VIPA System MICRO
Basics and mounting
Demounting > Demounting periphery module
HB400 | CPU | M13-CCF0000 | en | 16-47 28
To Next Page
Loading...
