CAUTION!
When installing a new firmware you have to be extremely careful. Under
certain circumstances you may destroy the CPU, for example if the
voltage supply is interrupted during transfer or if the firmware file is defec-
tive. In this case, please call our hotline!
Please regard that the version of the update firmware has to be dif
ferent
from the existing firmware otherwise no update is executed.
The CPU has an integrated web page that monitors information about the firmware ver-
sion of the SPEED7 components. The Ethernet PG/OP channel provides the access to
this web page. To activate the PG/OP channel you have to enter according IP parame-
ters. This happens in the Siemens SIMATIC Manager either by a hardware configuration,
loaded by memory card respectively Ethernet by means of the MAC address with ‘PLC
è Assign Ethernet Address’. After that you may access the PG/OP channel with a web
browser via the set IP address.
Ä
Chapter 4.6 ‘Hardware configuration - Ethernet PG/OP
channel’ on page 61
1. Go to www
.vipa.com
2.
Click at ‘Service Support è Downloads è Firmware’.
3.
Via ‘System MICRO è CPU’ navigate to your CPU and download the zip file to
your PC.
4. Unzip the zip file and copy the pgk file to the root directory of your memory card.
CAUTION!
With a firmware update an overall reset is automatically executed. If your
program is only available in the load memory of the CPU it is deleted!
Save your program before executing a firmware update! After a firmware
update you should execute a "Reset to factory setting".
Ä
Chapter 4.14
‘Reset to factory settings’ on page 78
Please note that with some firmware versions an additional firmware
update via alternate blinking (1Hz) of the red and yellow LED
can be indicated even when the operating mode switch is
in RUN position. In this state the CPU can only restart, if you establish a
further firmware update process. For this tap the operating mode switch
shortly downwards to MR and follow the procedures described below
.
1. Switch the operating mode switch of your CPU in position ST
OP.
2. T
urn off the power supply.
Display the firmware ver-
sion via web page
Load firmware and
transfer it to memory card
Transfer firmware from
memory card into CPU
VIPA System MICRO
Deployment CPU M13-CCF0000
Firmware update
HB400 | CPU | M13-CCF0000 | en | 16-47 77
To Next Page
Loading...
